Installing a hot and cold faucet can seem daunting, but here are the basic steps to follow:
Gather supplies: Before starting, gather the necessary supplies, including the faucet, supply lines, and plumbers putty.
Turn off water: Turn off the water supply to the sink by shutting off the valves under the sink.
Remove old faucet: Remove the old faucet if necessary by loosening the nuts and disconnecting the supply lines.Clean sink: Clean any debris or old putty from the sink surface.
Install gasket: Place the gasket over the mounting holes in the sink.
Insert faucet: Insert the faucet assembly into the gasket and through the mounting holes.
Install mounting nuts: Fasten mounting nuts on the faucet from below the sink, securing the faucet in place.
Attach supply lines: Connect supply lines to the hot and cold inlets on the faucet and tighten firmly.
Seal with putty: Apply plumbers putty around the base of the faucet to create a watertight seal.
Mount handles: Attach and tighten hot and cold faucet handles onto the mounting posts on the faucet spout.
Test faucet: Turn on the water supply, check for leaks, and test the faucet for hot and cold water flow.
Overall, the installation of a hot and cold faucet requires some basic plumbing skills and tools. Following these steps, ensure that you can install the faucet and enjoy a functioning hot and cold water system.