The shower, also known as the shower head, was originally a device for watering flowers, potted plants and other plants. Later, someone modified it to be used as a shower, making it a common device in the bathroom.
There are three types:
1. Portable shower: you can hold the shower in your hand and shower at will, and the shower bracket has a fixed function;
2. Overhead shower: The shower head is fixed at the top of the head, and the bracket is inserted into the wall. It does not have the function of lifting. However, there is a small movable ball on the shower head to adjust the angle of the water. The up and down movement angle is more flexible;
3. Body shower: The shower is hidden in the wall and sprays on the body side. It has a variety of installation positions and spray angles for cleaning and massage.
Shower base replacement
Step 1: Apply thread sealing paste or wrap sealing tape on the two joints, and then screw them into the hot and cold water supply pipes. Adjust the two joints so that the center distance is 150mm and maintain a uniform level; the middle decorative cover is screwed into the joint, close to the wall after decoration; the sealing gasket is installed in the nut, screwed to the joint, and tightened. Install the washers into the two ends of the shower hose, and then connect one end of the shower hose to the outlet of the faucet, and the other end to the shower.
Shower base is more
Step 2: First buckle the fixing pin from the bracket and take out the plastic sleeve. Take out the self-tapping screw and expansion plug from the inner cavity of the bracket. Choose a location for the mounting bracket at the height that the shower hose can reach. Mark the number of the mounting bracket bottom plate on the wall, and drill two holes according to the number. Insert the expansion plug into the hole, and then screw the self-tapping screw into the expansion plug through the plastic sleeve as shown in the figure, and tighten it with a screwdriver. Align the groove on the inner wall of the bracket with the boss of the plastic sleeve and insert, and then press the pin into the fixing hole of the bracket.